ReMark
发表于 2022-7-8 12:49:01
try by typing z> all
dustbear
发表于 2022-7-8 12:54:14
I have the exact same problem in AutoCAD Architecture...same commands mostly though. I have a Dell optical mouse though....the mouse wheel zooms fine. but it doesn't pan. at all.
mugshot
发表于 2022-7-8 12:55:16
sometimes pan got limited access even if it is usb, pop port, or cord less, it depends on the length of the drawing, try to zoom all your drawing then pan. zooming all the drawing for the limitation of the pan is base on your drawings, if you cant see the full thread of your drawing, so as to pan.
Fricai Andlat
发表于 2022-7-8 12:59:07
No, that didn't do anything either.
mugshot
发表于 2022-7-8 13:03:57
:?ouch! try first on the last post of remark... if still doesn't work. try the help desk... -pan sets only "s[ecify basepoint":whistle:
dustbear
发表于 2022-7-8 13:08:14
try first on the last post of remark... if still doesn't work. try the help desk... -pan sets only "s[ecify basepoint"
:cry:I don't get what you are asking me to do.
mugshot
发表于 2022-7-8 13:11:19
as per ReMark When you go to the Control Panel and click on mouse properties what does it say on the Hardware tab under Devices: Name?
...actually when u type -pan, you will be ask for a "specify base point" other than that is to press F1.
dustbear
发表于 2022-7-8 13:12:10
-pan works but I might as well right-click and select pan, or use the pan icon on the status bar, or select 'pan while in the middle of another command....all of which is time-consuming.
I should be able to push down on the scroll wheel to get "pan".