blittle 发表于 2022-7-9 07:08:09

Solidwork help required - Simp

Hi,
 
I am new to Solidworks and am learning the basics.
 
I am trying to design a simple part for a saxophone case.
 
The main part is simply an extruded shape with filleted edges.
 
The problem I have is with the bell curve which extrudes from the main part top and bottom.
 
Is it possible to simply use a dome or similar extrusion teqnique to bulge the area specifically at the point of the bell or do I need to do a more complicated 3d drawing to achieve a cone shape on both sides.
 
I have tried several different methods of achieving this but have not achieved anything yet that I am satified with.
 
Thanks,
 
Ben.

jkristia 发表于 2022-7-9 07:42:12

I would draw the profile and the do a revolve - or revolve cut to remove the part from you base shape

design-engine 发表于 2022-7-9 08:23:27

post a picture.   The use of surfacing could be required.
页: [1]
查看完整版本: Solidwork help required - Simp