cadplayer 发表于 2022-7-6 09:09:49

smooth polylines in line- and

Hi,
 
I have a polyline with line-entitys. Is it possible tosmooth this polyline in line- and arc-entitys

MSasu 发表于 2022-7-6 09:32:23

Did you checked the Fit and Spline options of PEDIT command?
 
Regards,
Mircea

cadplayer 发表于 2022-7-6 09:52:17

Yes but the result of pedit is not nice. Pedit draws a curve, I would like have a polyline which draws of line and tagential arc. Roaddesign works mostly with lines and arcs.

BIGAL 发表于 2022-7-6 09:55:35

You should re-read you road horizontal geometry guidelines again, the radius of curves and spirals are there so when your speeding you do not run off the road. You could though build a lisp taking into account your design paremeters and convert two straight lines joining now with the correct arc.

alanjt 发表于 2022-7-6 10:17:28

Just specify the radius and pick either side of the vertex with the Fillet command.
页: [1]
查看完整版本: smooth polylines in line- and