Sewer Linetype with size, type

Bakuku · 发表于 2022-7-7 00:02:30

Hello,

I use C3D 2011, and for the life of me I can't get it to work. I created the LT by using the Express tools>Tools>Make Linetype. I went through the procedures and here's the code:

copy

*8ACPSEWER,8ACP_SewerA,1.544489,[">",ROMANS,y=-.426442,s=1,u=0],3.602006,-.376281,["S",ROMANS,y=-.551197,s=1,u=0],-1.689956,1.544489,[">",ROMANS,y=-.426442,s=1,u=0],3.602006,-.769301,["8''ACP",ROMANS,y=-.602394,s=1,u=0],-5.675395

I know about the single quotes that's right after the 8 on 8''ACP. For some reason the LT spacing is all whacked. I can change that with the spacing, but what's not showing are the ">" with the LT. I have another LT that shows a flow line and it works fine.

Much appreciated if anyone can help me.

SLW210 · 发表于 2022-7-7 00:31:29

Try to see if it will work with STANDARD instead of ROMANS.

I got a bad definition at line 640 when I tried to load it.

Bakuku · 发表于 2022-7-7 00:46:40

Thanks for the reply.

I changed it, and I am still getting the samething. hrm....

SLW210 · 发表于 2022-7-7 00:56:48

Could you post an image of the linetype you are trying to make? Maybe there is a better way to make it.

Do you get any messages?

Bakuku · 发表于 2022-7-7 01:03:10

Hello again,

I don't get any messages. Here's a screen shot.

Sewer.pdf

Sorry had to trim it because the file was too big...

[综合讨论] Sewer Linetype with size, type

发表回复

精选推荐