Need help with viewport and 1:

psTopkat · 发表于 2022-7-7 22:43:04

I am running Acad2009 and doing interior elevations that need to be metric (mm) and 1/4" scale (1:50?) The model space is floor plan I received from the architect and the units are set to mm. I don't know how to tell what the drawing limits were set at or if that is what causing the issue defined below.

When I use MVSETUP to create 1:50 scale in viewport the viewport drawing becomes huge, so big can't see the image. I am setting the drawings up on ANSI A so I can use regular printer to review each elevation.

extmax= 59,330.6576, 49,621.9681, 0.0000
extmin= -34,079.0440, -476.8910, -0.0001

Help would be greatly appreciated.

Tiger · 发表于 2022-7-8 00:41:16

3277mm = 10'9"

1st thing I would do is check your dimension style there is a scaling factor that will then allow auto foot dims but drawing is in mm under "alternate units" "multiplier for all units" remember 1"=25.4mm 1'=0.3048m or 304.8mm acouple of goes should get the scale factor right.

[综合讨论] Need help with viewport and 1:

发表回复

精选推荐