How do I convert lines/arcs to

peterg · 发表于 2022-7-8 09:43:28

Using PEDIT how do I convert a number of lines & arcs into a polyline?

ReMark · 发表于 2022-7-8 09:52:20

Select the option to "join" then choose which lines and arcs (ends must be touching) you wish to join up. If the operation is successful your multiple lines and arcs will be become one entity.

peterg · 发表于 2022-7-8 09:57:19

PEDIT
polyline or multiple                      multiple
select objects                            lines selected
enter an option                         which one do I select
enter fuzz distance or joint type    ?

alanjt · 发表于 2022-7-8 10:05:19

copy

Command: pePEDIT Select polyline or [Multiple]: mSelect objects: Specify opposite corner: 8 foundSelect objects:Enter an option [Close/Open/Join/Width/Fit/Spline/Decurve/Ltype gen/Undo]: jJoin Type = ExtendEnter fuzz distance or [Jointype] :7 segments added to polylineEnter an option [Close/Open/Join/Width/Fit/Spline/Decurve/Ltype gen/Undo]:

peterg · 发表于 2022-7-8 10:07:55

I have tried this several times, but all the lines and arcs are still seperate lines & arcs, not one complete poly line is there something missing?????

alanjt · 发表于 2022-7-8 10:18:09

Do they all have different elevations? You can't PEdit>Join lines on different elevation planes.

peterg · 发表于 2022-7-8 10:23:55

I am drawing in the isometric grid, all the lines are in the same plane at the same height.

basically i have plotted 4 circles, drawn tangent lines from circle to circle & trimmed the circles to end up with a rectangle with radius corners.
hope this describes it ok

peterg · 发表于 2022-7-8 10:30:40

please see where I have added red text.

Coosbaylumber · 发表于 2022-7-8 10:35:11

They pretty well got the thing nailed down. But only thing I can think of is if you somehow got double lines. An out and back situation. The arc or line will then easier connect into the second line than to connect up the next line in a series. Thus you actually then are trying to connect in a line into the middle of one section, or you may be trying to connect in a rectangle to the figure. In either situation, it can't be done.

Wm.

ReMark · 发表于 2022-7-8 10:39:25

Why not try drawing the rectangle first (remember to use OSnaps) then fillet the corners?

[综合讨论] How do I convert lines/arcs to

发表回复

精选推荐