read-only

apostel · 发表于 2022-7-8 11:04:45

Hi Guys,

Next problem!
Because i got sick of geeting drawings in all diffrent versions of autocad and then ended up to not get these open "drawing not valid"...
Did i decide to purchase autocad 2010.
Now i just recieved new drawings and I get this message
"150-1.dwg is currently in use or is read only.would you like to open the read only "

I click yes and no drawing visuable
The most strangest is that i keep my mouse on a map in the file refernces then a small window jumps open where i see very small the compleet drawing- but i can not open this...

Any advice how to proceed?!

Thank you in advance!

nocturne00 · 发表于 2022-7-8 11:15:35

Can you post one of these drawings here for us to look at?

Cad64 · 发表于 2022-7-8 11:25:42

Hi Cad64,

This is at the moment not possible - because we work with NDA that prohibit us sharing these kind of info...
Im sorry...

apostel · 发表于 2022-7-8 11:33:44

apostel: Coosbay sometimes forgets there are only a handful of us on this forum, it seems, that remember the good old days of DOS (Disk Operating System).

Back then, if someone wanted to change the read only attribute from on (+r) to off (-r) they would go to the root drive (usually drive "C" and type...

attribute -r [drive][path][filename]

Example:

attribute -r C:/drawings/nda_1.dwg

That would be enough to remove the read-only attribute.

apostel · 发表于 2022-7-8 11:39:26

Just on one or two occasions, I have found that Microsoft Windows will lie to you. Which is why back in posting #6, I mentioned:

I have found that on occasion, depending upon the era and equipment the "Read-Only" message will appear, and once you get Microsoft Properties involved it says No problem. Well try as you may, there really is a problem.

Sometimes you have to try a few different things and see what works for you then.

Wm.

Coosbaylumber · 发表于 2022-7-8 11:49:30

The drawings may have been locked by an add on application, for an example see-
http://www.cadtutor.net/forum/showthread.php?t=39254

Have you tried using RECOVER instead of OPEN?

apostel · 发表于 2022-7-8 12:04:39

I once had troubles with the "Locked" biz a few years ago. To sucessfully UN-lock a drawing it had to be done via the very same terminal (one of six in that office). The others could see the project, and some could not, but of the remaining five, none could alter and keep a thing.

The Locking did not show up as a simple Micro-soft R file, so I do not know how it got connected in then.

But the Unlocking had to be done on that one particular terminal. The employee quit, and we had to keep his terminal active just to Unlock whatever he touched.

Wm.

Cad64 · 发表于 2022-7-8 12:11:13

Don't know enuf to comment on that; but keep an eye on this thread

http://www.cadtutor.net/forum/showthread.php?t=39255

NBC may give a idea on how to proceed.

[综合讨论] read-only

发表回复

精选推荐