How can I do typical rooms - E

yrnomad · 发表于 2022-7-8 17:37:26

To start, I'm still new to Revit...

We are doing an apartment building, where there are typical unit plans used throughout the building. (i.e. Unit 1A, Unit 1B, Unit 2a, Unit 2B....)

Not really knowing how this works from the Architectural side, I've guessed the Architect develops a Floor Plan for a "Unit 2A", then replicates it around the building, rotating/mirroring it as needed.

Is there a way to do this with my electrical devices and fixtures, creating it once, then automatically replicate it across all of each of that type?

Thanks.

tzframpton · 发表于 2022-7-8 18:08:06

Hmm, ok.
Maybe another question is in order. With AutoCAD, we didn't even reference them around the building. We'd make a sheet that had one of each type of unit plan, and show the wiring, devices and fixtures.
I thought about doing this with revit, but I was worried about the electrical load of each unit's Panel not showing up on the overall residential service load.

yrnomad · 发表于 2022-7-8 18:22:32

Your worry is correct. Since you answered the most important question - that of using Revit to actually circuit the devices and connect them to panels, calculating the VA loads/etc, then you need to not group them. Get one room done and copy them around as needed, then start circuiting them.

tzframpton · 发表于 2022-7-8 18:55:37

Thanks for the confirmation TZ.

[综合讨论] How can I do typical rooms - E

发表回复

精选推荐