can't target a line alone

Writz · 发表于 2022-7-8 21:02:41

i'm watching a video on youtube of a how to draw a helicopter blade, i understand what is going on in the video, but there is one point i can't follow. right when
.
I did exactly everything he did until that point, where i can't target the open loop(the line), instead it targets the sketch(3 lines connected to each other).

I attached my last progress file blade5.SLDPRT .. i'm using solidworks 2015 sp2.1

stevsmith · 发表于 2022-7-8 22:14:53

If you need a single line from a sketch you need to right click and use "selection manager". I didn't watch the video but im guessing that is the issue.

[综合讨论] can't target a line alone

发表回复

精选推荐